undefined
+
  • undefined

Bell-type high-temperature sintering furnace

Equipment Overview: This furnace utilizes high‑quality silicon carbide or silicon molybdenum heating elements, enabling long‑term operation at 1350°C and 1650°C with an extended service life. The insulation material is vacuum‑formed alumina fiber, an inorganic, environmentally friendly, and energy‑efficient solution. The sample holder features automatic lifting and sliding motion, ensuring smooth, vibration‑free operation, while facilitating safe and convenient loading and unloading of products and accelerating the system’s cooling rate. It is ideally suited for high‑temperature sintering of ceramic materials, silicon carbide, cemented carbides, metal powder products, carbon fibers, optoelectronic components, magnetic alloys, carbon materials, and other rare, refractory metals.

Keywords:

Close
  • 产品对比
Total X Clear all
  • Product Information
  • Product Video
  • Experimental Case
  • Accessories and Consumables
  • Technical Specifications

    (Customizable)

    Device model

    MF-1400C/1700C-I

    MF-1400C/1700C-II

    MF-1400C/1700C-III

    Heating method

    Silicon-carbon rod / Silicon-molybdenum rod

    Silicon-carbon rod / Silicon-molybdenum rod

    Silicon-carbon rod / Silicon-molybdenum rod

    Maximum operating temperature

    1400℃/1700℃

    1400℃/1700℃

    1400℃/1700℃

    Long-term operating temperature

    1350℃/1650℃

    1350℃/1650℃

    1350℃/1650℃

    Cavity dimensions

    300x300x400mm

    500x500x800mm

    700x800x1300mm

    Temperature control method

    Fuzzy PID control and self-tuning regulation, with intelligent 30-segment programmable control.

    Temperature control accuracy

    ±1℃

    ±1℃

    ±1℃

    Warranty period

    ·   One-year warranty, lifetime maintenance.

    · Consumable components such as the turntable, heating elements, and sample holders are not included.

    ·   Damage caused by process-related issues, such as the use of corrosive gases or strong acids and bases, is not covered under warranty.

    Precautions

    · It is recommended that the heating and cooling rates be ≤10°C/min.

    ·   It is recommended to place the sample in a crucible, rather than directly on the chamber floor.

    ·   This equipment is not equipped with a vacuum sealing system and is not recommended for use with toxic or explosive gases. An inlet connector can be installed to allow the introduction of an inert gas or oxygen.

    ·   As the equipment is used over time, small cracks may develop on the furnace lining. This is a normal occurrence, and the cracks can be repaired with an alumina coating.

Consultation Message